General:
REPEATER ICOM IC-FR6200H (DPMR VERSION) | ||
---|---|---|
FREQUENCY COVERAGE | 400–470MHz | |
NUMBER OF CHANNELS | Max. 32 channels | |
CHANNEL SPACING | 6.25/12.5/25kHz | |
TYPE OF EMISSION | 16K0F3E, 11K0F3E/F7E/F7D/F7W, 4K00F1E/F1D/F3E | |
FREQUENCY STABILITY | ±0.5ppm | |
ANTENNA IMPEDANCE | 50Ω (Type-N × 2) | |
OPERATING TEMPERATURE RANGE | −30°C to +60°C | |
POWER SUPPLY VOLTAGE | 13.6V DC | |
CURRENT DRAIN (AT 13.6V DC) | TX 50W | 11A |
RX MAX. AUDIO/STAND-BY | 1.2A/450mA (LCD backlight OFF) | |
DIMENSIONS (W×H×D) | 483×88×360 mm | |
WEIGHT | 10kg (approx.) |
Transmitter
IC-FR6200H (DPMR VERSION) | ||
---|---|---|
OUTPUT POWER 100% DUTY CYCLE | 50W (adjustable to 5W) 50W (at 20–35°C, 24 hours) | |
MAX. FREQUENCY DEVIATION | ±5.0kHz/±2.5kHz (W/N) | |
SPURIOUS EMISSIONS | 80dB typ. | |
FM HUM AND NOISE | 50/45dB typ. (W/N) | |
AUDIO HARMONIC DISTORTION | 1% typ. (40% deviation) | |
DIGITAL FSK ERROR | 5% Max. | |
MICROPHONE IMPEDANCE | 600Ω (8-pin modular) |
Receiver
IC-FR6200H (DPMR VERSION) | ||
---|---|---|
SENSITIVITY | 12DB SINAD | 0.25μV typ. |
5% BER | 0.25μV typ. | |
ADJACENT CHANNEL SELECTIVITY | 78/56dB typ. (W/N) 63dB typ. (Digital) | |
SPURIOUS RESPONSE | 80dB (W/N) 80dBμV emf (Digital) | |
INTERMODULATION REJECTION | 78dB typ. (W/N) 75dBμV typ. emf (Digital) | |
HUM AND NOISE RATIO | 50/45/55dB typ. (W/N/D) | |
AUDIO OUTPUT POWER | 4.0W typ. at 5% distortion with a 4Ω load | |
EXTERNAL SPEAKER CONNECTOR | 2-conductor 3.5 (d) mm (1/8″)/4Ω |
Applicable U.S. Military Specifications
Icom makes rugged products that have been tested to and passed the following MIL-STD requirements and strict environmental standards.
STANDARD | MIL-810 G METHOD, PROC. |
---|---|
LOW TEMPERATURE STORAGE | 500.5 I |
LOW TEMPERATURE OPERATION | 500.5 II |
HIGH TEMPERATURE STORAGE | 501.5 I |
HIGH TEMPERATURE OPERATION | 501.5 II |
LOW TEMPERATURE STORAGE | 502.5 I |
LOW TEMPERATURE OPERATION | 502.5 II |
TEMPERATURE SHOCK | 503.5 I-C |
HUMIDITY | 507.5 II |
VIBRATION | 514.6 I |
SHOCK FUNCTIONAL | 516.6 I |
Also meets equivalent MIL-STD-810 -C, -D, -E and -F.
All stated specifications are subject to change without notice or obligation.
Icom IC-FR6200H is compatible with both analog FM mode and dPMR single site conventional mode (Mode 2). Program digital and/or analog FM modes per channel. The mixed mode operation allows you to receive both analog FM and dPMR Mode 2 and to transmit either mode depending on the received signal.
Radio Base Station
50W Full Duty Cycle Digital Repeater
50W 100% Duty Cycle Operation
Employing a high performance power amplifier, together with the solid heatsink built into the chassis, the IC-FR6200H provides a reliable 100% duty cycle operation at 50W output.
32 Channel Capacity and 5 Programmable Buttons
The 12-digit dot-matrix display, 5 programmable buttons, 32 memory channels and internal speaker allow you to use the repeater as a simple base station or to check repeater activity. LEDs on the front panel show channel conditions.
dPMR™ Mode 2, Analog FM and Mixed Mode
The IC-FR6200H is compatible with both analog FM mode and dPMR single site conventional mode (Mode 2). Program digital and/or analog FM modes per channel. The mixed mode operation allows you to receive both analog FM and dPMR Mode 2 and to transmit either mode depending on the received signal.
Multiple CTCSS, DTCS Tone and CC Decode
The IC-FR6200H decodes multiple CTCSS and DTCS as well as digital CC on a per channel basis (up to 16 tones/codes) and downlinks the received signal with a specified tone/code. This function is useful for sharing a channel with multiple groups.
19-inch Rack Mount, 2U Height Low Profile Design
The IC-FR6200H uses only 2U height. This low profile configuration allows you to stack multiple units in an industry standard 19-inch rack and provides great space efficiency.
Other features
- CW ID transmission
- Digital voice scrambler provides 15-bit key (about 32,000 codes)
- ±0.5ppm high frequency stability
- D-SUB 25-pin accessory connector
- Built-in inversion voice scrambler*
- PTT priority setting (Local Mic., external PTT or repeater operation)
- Built-in audio compander*
- 5-Tone and DTMF encoder/decoder*
- Normal and priority scan
- Low voltage alert*
- Key assign stickers supplied
- IDAS and IDAS logo are trademarks of Icom Incorporated.
- All other trademarks are the properties of their respective holders.
Reviews
There are no reviews yet.